M2TECH PALMER POWER STATION User Manual download pdf (Page 10)

PALMER POWER STATION

LOW NOISE BATTERY POWER SUPPLY/CHARGER

REVISION P

B – DECEMBER 2011

M2Tech

www.m2tech.biz

Battery life can be increased by avoiding complete discharges: user should force a charge

cycle after a listening session even if the battery is not completely depleted. This is

obtained by powering the unit while the output switch is engaged.

Despite the aforementioned protection circuits, a Li-Po battery is a delicate device (even if

not as delicate as a Li-Ion battery) which needs to be properly used to avoid damages.

Particularly, do not expose the PALMER POWER STATION to excessive heat or cold or fire, nor

drop liquids on it. Do not short-circuit the outputs. Should the PALMER POWER STATION be

exposed to temperature beyond the allowed range, put the unit in a normal environment

and allow for at least one hour before operating it. Too cold or too hot a battery would

result in damage when operated. Please refer to the specifications section (Page 11) for

temperature limits.

Moreover, it’s advisable not to overcharge nor short-circuit the outputs in order to avoid

excessive stress to the battery and to the post-regulator.

5.4. Placement

The PALMER POWER STATION can generate heat during operation, particularly when charging

the battery and when the maximum output current is required. Do not place the PALMER

POWER STATION on carpets or moquette, allow for adequate ventilation, particularly at the

front panel. Venting holes are present to the right of the front counterpanel that should not

be covered.

1 2 ... 5 6 7 8 9 10 11

No comments

M2TECH PALMER POWER STATION User Manual Page 10